Alvarado MT Installation & Maintenance Instructions - Seite 2

Blättern Sie online oder laden Sie pdf Installation & Maintenance Instructions für Drehkreuze Alvarado MT herunter. Alvarado MT 2 Seiten.

Installation Instructions:

1. Verify the Turnstiles Model (

determine the proper centerlines of the Post(s). A tile line may be substituted for the chalk line. Allow a minimum

distance of 22.5" (MT/GST) from the center of the Turnstile Post to the center of the Yoke Post. Be aware that if

anymore than 3" is left between the Yoke Post and the Turnstile Arm, unwanted passage may be obtained.

2. Anchor the Posts and install the OV Rail according to the Vogue or Zenith Post installation instructions that are

provided with this document. Ensure that all OV Rails OV Posts are straight and level. All bolts should be tightened to

20-ft/lbs. torque using a 9/16" socket. Secure OV Rails with the ¼-20 x ¼" set screw found in the base package.

3. Install the Turnstile Head onto the Turnstile Post by pressing it down over the Clutch Assembly while rotating it in the

direction the turnstile will turn (to the left if counter-clockwise, or to the right if clockwise). Insert and tighten the

retaining bolt. Make sure that the retaining ring is centered such that the Turnstile Head slides easily over the Clutch

Assembly.

Installing the Turnstile Head.

4. Insert and tighten the (2) Head Screws with Lock Nuts to attach the Yoke to the Yoke Post. If applicable insert the

Cap to cover the top of the Yoke Post.

Clean turnstiles with the correct type of cleaner for it's finish. Follow the instructions below depending on the finish:

Chrome:

Use a general all-purpose cleaner with a soft cloth.

MAINTENANCE

Stainless Steel:

Use a Stainless Steel polish or cleaner. If a heavy scratch or mark is apparent, use a metal blend or finish pad.

Powder Coat:

Use a soft damp cloth. Any deep scratches or chips should be touched up to prevent rust.

(If rust is untreated, rush will spread under the surface of the material.)

Replace any sharp, bent, or broken pieces IMMEDIATELY. Tighten any loose anchors.

Alvarado Manufacturing Company warrants the equipment being sold against defects in material and workmanship, for the period

of one (1) year from the date of purchase, providing recommended installation and maintenance procedures are followed. This

warranty is void if damage was due to improper installation, maintenance, or use. The manufacturer will not be responsible for

WARRANTY

any shipping or labor charges incurred in the removal or replacement of defective parts.

MT / GST / SPT Turnstile Installation & Maintenance Instructions || PID3038R1-1 || 05/1/2009

) and snap a chalk line on the floor in the desired location(s) of the Post(s) to

TABLE 1

Turnstile Head

Retaining Bolt

Clutch Assembly

Lock Nuts

Yoke Post

Installing the Yoke.

Cap

Yoke

Head Screws