AKO 52068 Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Sicherheitssystem AKO 52068 herunter. AKO 52068 12 Seiten.

Pushbutton assembly

The pushbutton should be installed inside the coldroom, in a visible place and no higher than 125 cm from the

floor.

AKO-52062

-Remove the pushbutton's cover (Fig. 4).

-Drill the hole for the included gland needed for the cable entry following the pre-stamped centres on the bottom

of the base.

-Drill 3 holes on the wall following the fixing holes. (Fig. 5).

-Fasten the gland onto the base.

-Insert the 3 screws+plugs through the base, into the 3 holes on the wall and tighten.

-Insert the cables into the gland and connect them according to the wiring diagram.

-Insert the cover and gently press it until you hear a "click".

FIG. 4

Press gently

Fixing holes suitable for

universal built-in housing

AKO-520622

Fix to the wall using the holes for this purpose (A),

connect it to the alarm station by following the

wiring diagram and close the lid with screws

included.

Cable gland is included for cables between 6 and

12 mm Ø.

Recomended installation

The cable must make a 180º bend after exiting from the bottom of the pushbutton (as seen in the image) to prevent

water from reaching the wires.

180º

Max. Ø 3,7

FIG. 5

125,5

171

5206H701 Ed.03

Fixing hole detail

180º