aion MAELSTROM Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Musikanlagen aion MAELSTROM herunter. aion MAELSTROM 11 Seiten.

BUILD NOTES
Using SMD JFETs
The J201 JFET is no longer available in through-hole format. This PCB uses a hybrid through-hole/
SMD outline for each JFET. An extra "G" (gate) pad is included to accommodate surface-mount devices
without the need for adapters. SMD JFETs should be oriented as follows:
All surface-mount JFETs use the same pinout, so this configuration will fit any type that we're aware of.
However, always check the datasheet if you're uncertain—they're difficult to desolder.
J201 adapters
Many DIY builders are intimidated by the small size of surface-mount parts. Aion FX offers
J201s on adapters
so they can easily be used as through-hole parts.
Vintage Microtubes specifications
The Vintage Microtubes uses an almost identical circuit to the B3K, but with several parts substitutions
to give it more of a vintage flavor.
PART
NEW VALUE
R8
261k
R14
220k
R15
see note below
R17
330k
R21
10k
The only other addition is a 220n capacitor in series with R15. The Maelstrom PCB does not include
space for this capacitor. It can be omitted entirely (the unit will have slightly more bass available). Or,
you can "tent" it with the resistor by putting one leg of the capacitor in one pad of R15, one leg of the
resistor in the other pad, and then soldering the leads together above the PCB.
In addition, the VMT hardwires the Attack switch in treble boost mode (left toggle position) and the
Grunt switch in the highest-bass mode (right toggle position). It's recommended to include the switches
in this build and just be aware of the "vintage" positions.
Note: The Vintage Microtubes also uses 6.65k resistors for R9 and R16 instead of 6.8k. This is almost
certainly just due to manufacturing convenience since the unit is fully SMD and many brands of
precision resistors aren't available in E12 or E24 values. It's recommended to stick with 6.8k in these
two positions.
MAELSTROM BASS DRIVE
PART
NEW VALUE
R25
100k
C2
22n
C10
220pF
C14
220pF
pre-soldered
PART
NEW VALUE
C16
1n
C17
4n7
C18
1n
C19
1n
6