100% AIRCRAFT 80004-368-10 Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für Motorräder 100% AIRCRAFT 80004-368-10 herunter. 100% AIRCRAFT 80004-368-10 6 Seiten.
Seite druckenCOMFORT LINER AND CHEECKPADS
The comfort liner is connected to the helmet with four snaps. To remove this, gently pull on the red tabs
towards the upper left or right corner of the liner and unsnap the corners. Repeat this process on the
lower rear section to completely free the comfort liner from the helmet. To re-install, place the comfort
liner in the helmet, aligning the front of the liner with the front of the helmet.
The cheek pads are connected to the helmet using 3 snaps. To remove, gently pull the lower corner
closest to the front of the helmet and repeat for each snap until the cheek pad is removed. To reinstall,
refer to the instructions for removal.
WARNING: IF PLACED BACKWARDS, THE COMFORT LINER WILL NOT PROPERLY FIT IN THE
HELMET, COMPROMISING ITS FUNCTION AND SAFETY AND, IN THE EVENT OF AN IMPACT OR
ACCIDENT, COULD RESULT IN SERIOUS INJURY OR DEATH. THE LINER IS ESSENTIAL TO THE
INTENDED PERFORMANCE OF THE HELMET.
VISOR ADJUSTMENT AND REPLACEMENT
To adjust the visor, slightly loosen the side screws with a flat head screwdriver. Reaching under the
center of the visor, slightly loosen the adjustment screw with your fingers. Pivot the visor up or down to
the desired position. Hand-tighten the center adjustment screw to secure the position, then hand-tight-
en the side screws to fully hold in place.
To replace the visor, perform the above steps for adjustment but fully remove the screws and visor.
Place new visor and insert side screws first. Then insert center adjustment screw, adjust visor and
hand-tighten the screw.
WARNING: TAKE CARE NOT TO OVER TIGHTEN THE SCREWS. ONLY HAND- TIGHTEN THE
SCREWS. TAKE CARE NOT TO CROSS-THREAD THE SCREWS. DOING SO MIGHT CAUSE IR-
REPARABLE DAMAGE TO THE HELMET, NOT COVERED BY WARRANTY.
WARNING: IF VISOR BREAKS DUE TO IMPACT OR ACCIDENT, REMOVE AND REPLACE VI-
SOR IMMEDIATELY. DO NOT WEAR HELMET WITH A
TO DO SO MAY RESULT IN SERIOUS INJURY OR
DEATH IN THE EVENT OF AN
IMPACT OR AN
ACCIDENT.
BROKEN VISOR. FAILURE