Blue Clean Speedy Wash Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Hochdruckreiniger Blue Clean Speedy Wash herunter. Blue Clean Speedy Wash 16 Seiten.
Auch für Blue Clean Speedy Wash: Gebrauchsanweisung (20 seiten)

Seite drucken

Fig. 22

Fig. 23

En - 10

bottom up for same reason.

• If a stain is particularly tough, it may be necessary to re-

apply the detergent and use a stiff bristled brush to scrub

the stain. Subsequent power washing after brushing

should successfully complete your cleaning job.

Fixed Brush Use

• Attach the fixed brush to help scrup surfaces to get them

clean. Can be used on lawn furnitrue, automobiles, RVs,

motorcycle, boat ect.

• Use after applying soap to help get those tuff spots, then

use the fan spray nozzle to clean off the soap. Do not

allow soap to dry on what you are cleaning which can

cause the soap to dry and damage your property.

• Rinse out brush after use to keep it clean.

Cleaning nozzles

• A clogged or partially clogged nozzle can cause significant

reduction of water pressure coming out of the nozzle and/

or cause the unit to pulsate while spraying.

• Turn off the unit.

• Turn off the water supply to the unit.

• Relieve any pressure trapped in the high pressure hose

by squeezing the trigger 2-3 times, and then lock the

spray gun by pushing the lock button from left to right.

• Take off the nozzle. Using the nozzle tip cleaner provided

(or an unfolded paper clip), insert the wire into the nozzle

hole and move back and forth until debris is dislodged

(Fig. 22). Back flush water through the nozzle using

garden hose and highest pressure available (either

standard water nozzle or use your thumb over the nozzle

to create water pressure for back flush).

Tips

• If you hear the motor run intermittently when the trigger

is not being squeezed, that is normal. The pump is

priming itself so it is ready to operate when the trigger is

squeezed. Turn off the power washer if not being used

after five minutes.

• The o-rings on the bayonet end of the lances and

attachments should be cleaned regularly and lubricated

with non-water soluble grease.

• The screen inside the clear adapter should be cleaned

periodically. Insert a pen or pencil in small hole at the end

of the adapter. The screen filter will slide out (Fig. 23).

Rinse it with clean water, and then place it back in the

adapter. Keep the nozzle cleaning wire that is taped to

this manual, to unclog the nozzle on the lance. If you lose

the cleaning wire an unbent paper clip will work.