Dobinsons BU19-3542 Installationshandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Installationshandbuch für Zubehör für Kraftfahrzeuge Dobinsons BU19-3542 herunter. Dobinsons BU19-3542 14 Seiten. Bullbar ford ranger px mk 2

Seite drucken

46. Install the side plates and tighten all nuts and

bolts in all under protection plates.

47. Check over all items removed during

installation.

48. Trim the wheel arch splash guards level with

the bottom of the under protection plates and

secure.

49. IMPORTANT NOTES: It is important to inform

the customer that headlight adjustment may

also be required due to the change in ride

height. It is also important to inform the

customer that there will be a change in

vehicle handling characteristics. It is also

important to note that due to their nature fog

lights are required to provide a yellow light to

allow clear fog vision. For this reason

Dobinsons bullbars utilise a Halogen bulb.

Halogen bulbs generate a considerable

amount of heat to achieve the yellow colour

and this causes the air inside the fog light lens

to expand and contract. For this reason the

fog light assembly cannot be sealed and has a

small breather on the back. In some cases this

may cause condensation to form inside the

fog light. The customer may choose to seal

the lens of the fog light but must not seal the

rear breather.

In some vehicles there is a possibility of noise

interference with the radio in some

conditions. If this is experienced then it is

recommend to fit the genuine FORD antenna

interceptor wiring kit part number

EB3T18812SAA. This part is used with genuine

FORD bullbars that experience the same issue,

Dobinsons Springs and Suspension

itting instructions for the part are available

through FORD.