ET2 E42016-90AL Schnellstart-Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Inneneinrichtung ET2 E42016-90AL herunter. ET2 E42016-90AL 4 Seiten. Led mirror

Seite drucken

IMPORTANT:

-Turn off the power at the main fuse or circuit breaker box before starting

installation

-This mirror can be mounted over an electrical outlet box or on the wall and

plugged into an outlet

-Carefully remove all parts from the box, and place on a flat surface. Throughout

the assembly, be careful to avoid scratching the surface of the mirror.

Step 1

WALL TEMPLATE

Cleaning & Care:

Clean glass with household glass cleanser.

Step 2 - Step 3

MARK

4PCS

Step 4

Step 5

1.) Place the wall template of the

mirror on the wall in the location

selected for the mirror. Make sure the

wall template or mirror is level and in

the correct position. Secure the wall

template to the wall then mark location

of the 4 wall anchors(A) as indicated

on the template from the wall.

Remove the wall template from the

wall.

2.) Create holes on wall marks and

screws the (X4) wall anchors (A).

3.) Secure (X4) nails (B) into (X4) wall

anchors (A).

4.) Hang (X4) wall hangers (C) on the

back of mirror onto (X4) nails (B). If

wall is not mounted parallel to floor,

repeat step 4.

5.) Plug cord into closest power outlet.

OR before step 5, cut the plug and

connect the wire with junction box

wire.

*IMPORTANT SAFETY INSTRUCTIONS

This mirror has a 3 pins plug, once the

plug is cut, the 3 core

wire(phase/neutral/ground) will be

exposed then can connect with

phase/neutral/ground which come out

from junction box

MADE IN CHINA

Page 4 of (4)