DockCraft 100 Series Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Bootsausrüstung DockCraft 100 Series herunter. DockCraft 100 Series 15 Seiten.

To "Lock" the Brackets and Pivot Laterals together insert "Locking Pin" on both sides of unit.

If Clevis Pin with Circular Retaining Ring in Hole 2 or 4 of Pivot Lateral is seated in the Top Slot.

If Clevis Pin with Circular Retaining Ring in Hole 2 or 4 of Pivot Lateral is seated in the Bottom Slot

Webbing Length Adjustment :

On page 3 you set the webbing mark at the cam buckle.

This setting is a nominal setting for kayaks with a width of 27 to 29 inches. Based on the width and

contour of your kayak, this setting may vary.

This setting has 2 purposes:

1 –

To accommodate the size

and contour of your Kayak

2 –

To allow your Kayak to sit at

an angle to minimize rain

entering the Kayak and

therefore collect in the cockpit

3 – Load your Kayak into your rack and rotate to the Kayak Storage Position by:

a: Rotating the Cradle toward the water such that the handle is parallel with the water.

With the Dockside Operation model do this using the tether strap.

With the Waterside Operation model do this by standing in the water and centered on your rack,

grasping the handle and rotating toward you.

SETUP of "The DockSider"

Insert 2

Clevis Pin through hole in bracket

and secure with

"R" Retaining Clip on opposite side.

Insert 2

Clevis Pin through hole in bracket

and secure with

"R" Retaining Clip on opposite side.

Page 9 of 15

TM -

continued