DockCraft CR 100 Handbuch - Seite 13

Blättern Sie online oder laden Sie pdf Handbuch für Bootsausrüstung DockCraft CR 100 herunter. DockCraft CR 100 15 Seiten.

Seite drucken
Canoe Dock Rack
Bolt on Mount
- Bolts in 2 locations per Mount
- 2 Mounts per Dock Rack
Surface Mount (Bolt On) Mount Overview
Wood Dock with Decking on top of Side Board
Ideal for situations when the underside
of your Dock is not accessible
- Floating Docks -
Wood Decking overhanging Dock Sideboard
"The DockSider" Mounting Options
DockCraft Industries Bolt On Mount for "The DockSider"
Boat Docks come in many different configurations
Location #2 - 5 inches
Location #1 - 2 1/4 inches
Location #2 - 5 inches
Location #1 - 2 1/4 inches
- Canoe Dock Lift -
Decking
1 inch to 1 1/2 inch thick
Dock SideBoard
Typically 1 ½ inch wide
Standard Hardware – Included in Purchase
- 1/4 -20 x 2 ½ inch Stainless Steel cap screw, each location
- ¼ inch Stainless Steel washer, each location
- Stainless Steel Snap Toggler, each location
Standard Installation Requirements
•Drill ½ inch diameter holes in locations shown
•Insert Snap Togglers per directions from top of Dock
•Insert screws and washers then secure.
Hardware
- Standard Hardware
- 1/4 x 2 ½ inch Stainless Steel lag Screw – location #1, not included
- ¼ inch Stainless Steel washer, each location
Installation Requirements
•Standard Installation; except
•Location #1, Drill 1/8 or 3/16 inch pilot hole through decking and
into side board.
•Insert Lag Screw and washers to secure.
Page 13 of 15
Location #2 - 5 inches
Location #1 - 2 1/4 inches