DockStar Smart Thruster Betriebshandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Bootsausrüstung DockStar Smart Thruster herunter. DockStar Smart Thruster 15 Seiten. Stern
Auch für DockStar Smart Thruster: Installationshandbuch (16 seiten)
Seite druckenUsing the Faceplate Features: There are four components on the Smart Thruster faceplate:
1. The antenna (which does not come installed, please screw it in finger tight only. Do not over-tighten).
2. The On/Off button – Press in for ON, press out for Off. The blue LED in the center of the On/Off button
blinks in a number of patterns to provide status information. Please see Table 1 later in this document to
see the various blinking patterns.
3. The Battery Charging Port – Remove the charger port cover to access the charger jack. Plug the battery
charger into the charger jack when recharging the batteries. Plug the "pairing plug" into the charger jack
when pairing the thruster with the radio transmitter. Plug the charger port cover into the charger port
grommet at all other times. Do not use the charger port cover lanyard to pull the cover out. Instead, pry
the cover off with your finger nails. It is very important that the charger port cover is in place at all times
except when charging or pairing. This keeps water from entering through the connector which could damage
the thruster electronics.
4. The USB Port – This port is not for customer use. It is used by DockStar to perform final system testing and
to do field diagnostics. Please leave the rubber grommet in place at all times.
DockStarThrusters.com
Figure 4: Smart Thruster Face Plate
Page 11 of 15