Fleetminder platinum nxtg Installationshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationshandbuch für GPS Fleetminder platinum nxtg herunter. Fleetminder platinum nxtg 12 Seiten.

• Input 3 is Positive trigger (12V+ or 24V+)

9. Connect the

10. Connect the Wiring harness to the device to turn the

Fleetminder ON!

• Watch the LED's on the side of the unit to see the state of the

Note: The YELLOW and Green LED's will not be on until the system goes to full

working mode, normally 30 seconds after power on.

(This is in case the unit is in GPRS coverage)

Please refer to page 7 the LED Troubleshooting.

11. To test that the device is working correctly, move the vehicle

outside, ensuring that the GPS antenna has a clear view of the

sky.

For GPRS tracking, the LED indicator should show:

RED (ON), YELLOW (FLASHING), GREEN (ON)

For testing of the unit, the Primary phone number must be used using

SMS. Refer to the User manual for further instructions.

(Please refer User's Manual [section 8.1])

12. Start tracking

• On-line Tracking

• SMS Tracking

RED

wire to 12V+ or 24V+

device. Please refer to the LED state explanation form for

reference.

If online tracking was ordered with the device, it should already

be set up to start monitoring the location. Refer to your service

agreement which will include your username, password and the

software link.

Refer to Command list for setting up the device using SMS.

Page 4

fleetminder Installation Manual