DOD FX7 Benutzerhandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Aufnahmegeräte DOD FX7 herunter. DOD FX7 18 Seiten. Dod guitar effects processor/preamp owner's manual fx7
Seite drucken
BANK
or
1
2
3
Editing Programs
DATA
Delay
Delay
11-19 Mono 100ms
21-29 Mono 200ms
31-39 Mono 250ms
41-49 Mono 300ms
51-59 Mono 350ms
61-69 Mono 400ms
71-79 Mono 500ms
DATA
FX7 owner's manual
signal processing
1) After you power up, the FX7 defaults to Program mode. Select
a Bank by pressing the Bank selector footswitch. The display
shows the selected bank number on the left side of the display
and a dash on the right. The display might look something like
this:
2) Press footswitch 1, 2, or 3. The dash in the display changes to
show the number of the Program you selected. The display
might look something like this:
NOTE: If a new Program number is not selected within 5 seconds
after pressing the Bank select button, the display returns to its pre-
vious setting.
As you become more familiar with the FX7, you may find that you
need to modify certain Programs to better fit your needs. Fortunately,
the FX7 is flexible enough to give you everything you need without
being difficult to program.
The following procedure is an example of how to modify your
Programs. Suppose that Program 33 (which has a 100 ms mono
delay, a medium chorus, noise gate, EQ, distortion, and compression)
sounds close to what you want, but you want a 300 ms delay with low
feedback instead. Here's how to change it:
1) Use the Data wheel, or the Bank and Program selector
footswitches to select Program 33.
2) Press the Delay effect group button. The Delay group Status
LED begins flashing and the display reads:
11
3) Look at the front panel Delay groupings to locate the effect you
want. In this case, you'll see that the 300 ms mono delays can
be found between 41 and 49 in the Delay (not Multi-Delay)
Group.
4) Use the Data wheel to scroll until the the display reads:
41 .
2-_
23
9