DOD Acoustic1 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken DOD Acoustic1 herunter. DOD Acoustic1 18 Seiten. Guitar preamp/fx processor

Acoustic One owner's manual

signal processing

7) VOLUME CONTROLLER INPUT - This 1/4" connector is used to

connect most volume pedals or 0/+5v controller pedals to the

Acoustic One for real-time control of volume functions.

8) AC POWER INPUT - Connect the supplied AC power adapter

to this jack. Use only the adapter supplied with the Acoustic

One. Use of any other adapter may damage the unit.

9) POWER CORD STRAIN RELIEF - This clip prevents the AC

power cord from being accidentally pulled out.

DO NOT APPLY POWER TO THE ACOUSTIC ONE UNTIL INSTRUCTED.

STEREO: Connect the Left and Right outputs to a pair of guitar

amplifiers or the inputs of a mixing console. If you're using guitar

amps, set the tone controls flat (no boost or cut) and balance the

levels between them. If you're using a console, pan the Acoustic

One input channels hard left and right and turn down the high

frequency EQ for best results.

MONO: Connect the Left output to a guitar amplifier or input of a

mixing console.

Connect your instrument to the input of the Acoustic One.

OPTIONAL: Connect a volume type or 0/+5v controller pedal to

the Controller input of the Acoustic One. Make sure the pedal is

connected before you apply power to the Acoustic One.

Power up the Acoustic One by connecting the supplied AC

adapter between the Acoustic One and a power outlet.

Play your instrument and watch the Clip LED on the Acoustic One

carefully as you set the Input knob. Turn up the input level until

the Clip LED begins to light and back off the knob slightly. When

the Input knob is set properly, the Clip LED should not flicker on

the loudest passages. It is important to remember that In

bypass/tuner mode, the clip LED will not light.

Set the output level as desired.