DOD SR460 Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für Verstärken DOD SR460 herunter. DOD SR460 4 Seiten.

Seite drucken

Headphone Amp Man.

6/8/99

NTRODUCTION

Congratulations, and thank you for your purchase of the DOD SR 460 Stereo Headphone Amplifier. The SR 460

provides you with Left, Right and Stereo inputs, and 6 outputs. In addition, each output has independent level

control as well as a master level for all 6 channels. Another unique feature to the SR 460 is its slow audio ramp-

up feature. The audio has an approximate 750 millisecond ramp-up time on power-up to prevent damage to

hearing caused by loud audio pops. It also gives you time to turn down the volume if previous settings are too

loud. All inputs and outputs are 1/4 inch TRS

The SR 460 is another innovative product brought to you by DOD Electronics.

RONT PANEL FUNCTIONS

The front panel and controls of the SR 460 headphone amplifier are as follows:

1. STEREO FRONT INPUT/OUTPUT - A high impedance, high sensitivity plug-in connection that acts as an

output or a Loop-through input.

2. CLIP LED -

3. MASTER OUTPUT -

4. OUTPUT LEVEL CH. 1 -

5. OUTPUT CHANNEL 1 -

6. OUTPUT LEVEL CH. 2 -

7. OUTPUT CHANNEL 2 -

8. OUTPUT LEVEL CH. 3 -

9. OUTPUT CHANNEL 3 -

10. OUTPUT LEVEL CH. 4 -

11. OUTPUT CHANNEL 4 -

12. OUTPUT LEVEL CH. 5 -

13. OUTPUT CHANNEL 5 -

14. OUTPUT LEVEL CH. 6 -

15. OUTPUT CHANNEL 6 -

16. POWER SWITCH -

Note : To optimize the performance of the SR 460, it is recommended to use the AKG™ K270 Headphone.

10:57 AM

Page 2

This LED indicates internal signal clip from input device.

This control controls the overall amount of signal fed to each channel.

This knob controls the output of signal in channel 1.

This jack is used for the headphone output in channel 1.

This knob controls the output of signal in channel 2.

This jack is used for the for the headphone output in channel 2.

This knob controls the output level in channel 3.

This jack is used for the headphone output in channel 3

This knob controls the output level of channel 4.

This jack is used for the headphone output of channel 4.

This knob controls the output in channel 5.

This jack is used for the headphone output of channel 5.

This knob is used for the output level control in channel 6.

This jack is used for the headphone output of channel 6.

This switch turns the AC power either On or OFF.