DOD VoFX Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Computer Hardware DOD VoFX herunter. DOD VoFX 16 Seiten. Vocal fx processor/mic pre

SECTION 2 - PROGRAMMING THE VoFX

The VoFX is designed to be both easy to program and flexible. The structure of

an VoFX Program is logical, and it doesn't require a lot of time to master.

To Select Programs in the VoFX:

1) After you power up, use the Data wheel to scroll through the Programs. As

you scroll, the effect group and footswitch LEDs turn on and off. These LEDs

indicate which effects are used in each Program, and which Program in the

Bank is selected.

There are 13 effect groupings printed on the front panel of the VoFX. 9 are

digital effect groups (delay, reverb, etc.) , and 4 cover the preamp section

(compression, Mic Driver, EQ). Each group has its own LED that indicates

the status of each group.

If the Effect LED is lit continuously, an effect in the indicated group is active. If

the LED is not lit, no effects in the group are active. If the LED is flashing, edit

mode is active, and effects in the group can be selected using the Data wheel.

Directly below each vertical group are the <Effect Selector buttons>. These but-

tons allow you to select and/or bypass effects in the VoFX. The following things

happen when you use the Effect Selector buttons:

• When you select a bypassed effect, its group LED begins flashing and the dis

play shows two dashes, indicating that the effect is selected but bypassed.

(Pressing the Select button again activates the effect.)

• When you select an active effect, its group LED begins flashing and the dis

play shows the number of the currently selected effect. (Pressing the button

again bypasses the effect.)

When lit, the User LED below the display indicates that the current Program is a

User Program. When the LED is not lit, the current Program is a permanent

Factory Program.

The VoFX's pedalboard consists of four footswitches: the far right footswitch is

the Bank selector, and the remaining three are Program selectors.

A Bank is a group of three Programs. There are 10 User Banks in the VoFX,

each with 3 Programs for a total of 30 User Programs. There are also 30 Factory

Programs that can be selected using the Data wheel only. User Programs in any

of the Banks can be recalled in one of two ways:

• by pressing the Bank select footswitch, followed by footswitch 1, 2, or 3.

Signal Processing