Etac Molift MRS Duo 2500 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Mobilitätshilfe Etac Molift MRS Duo 2500 herunter. Etac Molift MRS Duo 2500 12 Seiten.

Adjusting post heights

1. Lift the inner post and pull out quick release

bolt.

2. Lift post to desired height and insert quick

release bolt trough outer post.

3. Look at height labels and ensure that both

post are adjusted at the same height.

Don`t stand under boom when

adjusting post height

Make sure quick release bolt is

properly installed

Don`t lift boom any higher when

stop sign appears on height label

1. Lead the end stops to the desired position and

tighten them.

2. Make sure the liftmotor does not hit the post.

3. Use allen key (located in top of post) to screw

in bolts.

Assembly

1. Remove plugs from holes on the post.

2. Use the small allen key (located in top of post)

to fasten screws.

3. Fasten the lower screw ﬁrst.

4. Place charger on screw and insert second bolt.

Don`t start using MRS Duo before

completing control according to

checklist after assembly.

Use this checklist to verify that the MRS Duo is

properly installed and can operate correctly and

safely before use.

Make sure both bolts in foot are properly

fastened.

Make sure all four bolts on boom are prop

early fastened.

Make sure quick release bolts are correctly

installed

Make sure end stops are properly fastened

Molift MRS Duo / www.etac.com