Etac Twin Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Wheelchair Etac Twin herunter. Etac Twin 8 Seiten. Cross-folding wheelchairs
Auch für Etac Twin: Benutzerhandbuch (8 seiten)
Seite drucken
Rear wheels:
Tyre pressure:
Castors:
Chassis:
Upholstery:
In the event of problems, contact your dealer or Technical Aids Centre.
(!) If necessary, lubricate moving parts/joints with cycle oil or similar.
The wheelchair is pulling
diagonally
The wheelchair is "heavy" to
manoeuvre
The wheelchair is awkward
to turn
The brakes are poor
The rear wheels are "loose"
The rear wheels are difficult
to get on/off
The castors "wobble"
The wheelchair is difficult to
fold up/unfold
The wheelchair feels
"unsteady"
Etac
Box 203, 334 24 Anderstorp
Tel +46 371 58 73 00
Fax +46 371 58 73 90
www.etac.com
Clean quick release axles as required.
Check the tyre pressure, see tyre section (once/month).
Clean castor wheel axles as required.
Clean the chassis with non-abrasive detergent, pH value 5-9 or
with 70 % disinfectant solution. Rinse and dry.
Wash, see labels on each item.
Troubleshooting table
•
Pump up the tyres
•
Adjust the angle of the front fork attachments
•
Check that the front fork attachments are fitted at the same height
•
The rear wheel mountings are incorrectly fitted
•
The user's weight is not evenly distributed in the wheelchair
•
More strength being used on one side than the other when propelling
the chair
•
Pump up the tyres
•
The rear wheel mountings are incorrectly fitted
•
Clean any hair and dirt from the castor axles
•
Too much weight over the castors; adjust the chair's balance position
•
Pump up the tyres
•
Check that the front forks are not tightened too much
•
Clean any hair and dirt from the castor axles
•
Too much weight over the castors; adjust the chair's balance position
•
Pump up the tyres
•
Adjust the distance between tyre and brake
•
Adjust the hub axle length
•
Lubricate and clean the quick release with cycle oil or similar
•
Adjust the hub axle length
•
The front forks have not been tightened sufficiently
•
Check that the front fork attachments are fitted at the same height
•
Adjust the angle of the front fork attachments
•
Too much weight over the castors; adjust the chair's balance position
•
The upholstery is too taut
•
Lubricate and clean the cross frame fittings under the seat
•
Pump up the tyres
•
Check that screws and controls are properly tightened
8
Maintenance
Etac Supply Center AB
Långgatan 12
SE-334 24 Anderstorp
Sweden