Clinton 81360 Betrieb, Pflege und Wartung - Seite 4
Blättern Sie online oder laden Sie pdf Betrieb, Pflege und Wartung für Inneneinrichtung Clinton 81360 herunter. Clinton 81360 8 Seiten. Shrouded power tables
Seite drucken
ADJUSTMENTS
(continued)
BACKREST CYLINDER REPLACEMENT (models 81200, 81330, 81350 & 81360 only)
The backrest cylinder is replaceable in the field by following these simple directions below.
Tab
Cylinder Pin
Remove cotter pin. Then remove
the slide-out pin. Position tab
located on the adjustment bar
against cylinder pin.
STIRRUPS (model 81360 only)
Stirrups are shown in the stored position in photo below at left. When extended, stirrups have two width
positions. Position 1 is the narrowest and Position 2 the widest. The length of the stirrups can be adjusted by
moving the stirrup slider to the desired location. When the patient applies foot pressure to the stirrup, it will
automatically lock into position. To return the stirrups to the stored position, fold the stirrup over onto the
slider bar and slide BOTh towards the head end of the table. The stirrup will store under the upholstered top.
Stirrups in the stored position
align holes in cylinder bracket with holes in table bracket by adjusting
the angle until the holes line up. Install slide-out pin through holes and
replace cotter pin.
Stirrup
Stirrup
Slider
Stirrup positions
Finished view of cylinder assembly.
Stirrup Position 1
Stirrup Position 2