Cyklos CCR 40 Betriebshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Trimmer Cyklos CCR 40 herunter. Cyklos CCR 40 6 Seiten. Corner rounding machine

6 Operating instructions

a) Read all instructions carefully before starting work on the machine.

b) After unpacking mount on the lever with the handle (7).

c) Insert the holder (4) into the slide clamp (3). Screw a base on the clamp and then

tighten the holder with a shaped bolt in a required position.

Introduce paper sheets between the stops (2). The stops must be adjusted parallel to the

lower tool (8) edge. The fine adjustment of the stops is completed after by means of a

milled nut releasing arrestment screws.

Adjust the holder so that it imposes sufficient pressure on paper even before cutting

begins, about 5 mm above paper stock. Then tighten the holder properly in the clamp by

turning the shaped screw towards the slide.

•

Remove impurities from the bearing surfaces of the rounding machine's tools.

•

Mount the upper part of the tool in the slide using screws. The tool must lean on

the upper edge. For easier handling, remove the holder from the assembly.

•

Hold the lever in its lower position (the bottom dead center of the slide). Attach the

bottom part of the tool to the upper part and tighten it with two screws – this will set

a shear clearance (T-squares have to be moved apart when inserting the lower

tool.).

•

Test the shear without using force. During shearing there must not be any contact

between tools and the set clearance of the tools must be secured along the whole

cutting length of the tool. See the picture.

Vůle ...... Clearance 0.01 mm

Nástroj – horní část ... Tool – upper part

Nástroj – spodní část ... Tool – lower part

Operating Instructions | CCR 40