DogWatch Hidden Fence System Benutzerhandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Haustierpflegeprodukt DogWatch Hidden Fence System herunter. DogWatch Hidden Fence System 15 Seiten.
Auch für DogWatch Hidden Fence System: Benutzerhandbuch (14 seiten)
Seite drucken
8. PowerPakTM: Optional battery back-up system keeps the transmitter operating in the
event of a power failure. When transmitter is being powered by battery back-up, the red
power light will remain off. PowerPak plugs into the transmitter at "P-PAK".
9.
Model Switch: This switch sets your transmitter to work with your specific receiver(s).
Set the switch in the "up" position for Systems 1000, 2000, 3000; set to "down" for
Systems 100, 200, or 300. Transmitter must be turned off when setting or changing this
switch.
RECEIVER
The lightweight radio receiver worn by the dog identifies the coded radio signal from
the boundary wire. It creates an audible warning followed by electrical stimulation to
deter the dog if he comes too close to the boundary wire. It operates on a replace
able battery and is waterproof when the battery cap is properly seated.
Figure A.
Battery
MUST be
placed
POSITIVE
(+) end
FIRST!
RECEIVER
FEATURES
Adjustable Collar: Each receiver comes fitted to an adjustable nylon collar. The collar
should be positioned above the dog's regular collar with the battery cap facing down
ward.
It should be adjusted to insure that the contact posts touch the skin on the dog's
neck. Check the fit for the first few days of wear to insure that the collar is not too tight
or causing irritation to your pet's neck.
* * *
IMPORTANT
* * *
DogWatch recommends that you remove the collar at night while your •et is inside.
Contact Posts: The receiver comes with two sets of contact posts: long, medium, short o
short wide. You should determine the correct set based on your dog's neck shape, coat,
and skin sensitivity. In general, the short wide posts work best with short fur and the medi•
um posts with medium or long fur. The posts must make contact with the skin in order for
the dog to feel the electrical stimulation. In certain cases, it may be helpful to clip some ol
the hair around the contact posts so that they can touch the skin more easily. Use care
when tightening contact posts with the collar wrench, as over-tightening could cause dam
age to the receiver.
Antenna: The receiver incorporates an omni-directional antenna design. Utilizing multiple
antennas on the receiver assures optimal reception from the signal field.
Battery: The receiver is powered by a 3.6 volt lithium battery The receiver is designed for
long battery life of up to one year dependent upon the rate of the transmitter and the cor
rection level of the receiver. A high correction level and a fast rate will drain a battery more
quickly than the lower levels and rates. The Dositive (+1 end of the battery must be
inserted first. When you first insert the battery, you will hear a series of beeps indicating
that the receiver is active. (Please note battery handling instructions marked on battery.)
Test LIght: The test light allows you to test the receiver. Hold the test light over the contac
posts as shown below and carry the receiver into the signal field. When the receiver picks
up the signal from the boundary wire, the audible warning will sound and the test light will
come on (Figure B).
Safelinle Digital FM Design: Our exclusive digital FM microprocessor design (patents
pending) allows the DogWatch receiver to recognize and activate only to our unique radio
signal. This protects your pet from false activation caused by stray radio signals which
may be emitted by other household and yard electronic devices.
Automatic Shutdown: The DogWatch system is designed to protect your dog from an
over-correction in the unlikely event that your dog gets caught in the signal field. If your
dog does not exit the signal field, the Receiver will automatically stop correcting after 15
seconds
—
protecting your dog from over-correction. The Receiver will automatically reset
once the dog leaves the signal field.
Figure
8.
Adjustable
Nylon Collar
Test Light
Battery Cap
Battery
Hold Magnet
Between Two Lines
'Feature not available on System 1000