DogWatch System 1200 Betriebsanleitung - Seite 4
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Haustierpflegeprodukt DogWatch System 1200 herunter. DogWatch System 1200 16 Seiten. System
Auch für DogWatch System 1200: Installationshandbuch (10 seiten), Benutzerhandbuch (12 seiten), Betriebsanleitung (9 seiten)
Seite drucken
SYSTEM 1200 RECEIVER FEATURES
Adjustable Collar: The receiver is attached to
an adjustable nylon collar. The collar should be
positioned above the dog's regular collar.
Adjust the collar to insure that the contact
posts touch the skin on the dog's neck. (Figure
3) Check the fit for the first few days of wear to
insure that the collar is not too tight or causing
irritation to your pet's neck. It is recommended
that you remove the collar at night while your
pet is inside.
Contact Posts: Your DogWatch Dealer will determine the correct size and type of
contact posts based on your dog's neck shape, coat, and skin sensitivity. The posts
must make contact with the skin in order for the dog to feel the stimulation. In certain
cases, it may be helpful to clip some of the hair around the contact posts.
Tighten the contact posts only with the collar wrench provided. Use of pliers or
similar tools can result in over-tightening, which can damage the receiver.
Antenna: The receiver incorporates an omni-directional antenna design. The use of
multiple antennas in the receiver assures optimal reception from the signal field.
Figure 4
into the signal field. If your dog does not exit the signal field, the receiver will auto-
matically stop correcting after 15 seconds to protect your dog from over-correction.
The dog will also receive a "warning" correction every 15 seconds which will contin-
ue until he leaves the field.
Receiver Settings / Training Levels
System 1200 incorporates 4 training levels plus an audible only setting. Level 1 is
a very low correction setting that in many cases is an appropriate training level for
timid pets. Levels 2 and 3 are progressively stronger training levels. Level 4 is
designed specifically for pets that require higher correction levels in order to be
contained. Your DogWatch Dealer will set the receiver to the appropriate training level
for your pet.
All settings are designed to be Pet Friendly™ and will not harm your dog.
Setting and Changing the Training Level
Hold the test light with the magnet end at the marks on the side of the receiver (as
shown on page 3). Hold the magnet steady and you will hear a series of beeps as
the Training Level advances. The Training Level will continue to advance as long
as the magnet is held in position.
Test Light: The test light allows you to test the receiv-
er. Hold the test light over the
contact posts. (Figure 4) and carry the receiver
into the signal field. When the receiver picks up
the signal from the boundary wire, the audible warning
will sound and the test light will come on.
Automatic Shutdown: The DogWatch System
is designed to protect your dog from an over-
correction in the unlikely event that your dog walks
- 2 -
Figure 3