DogWatch PT4 Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für Transmitter DogWatch PT4 herunter. DogWatch PT4 2 Seiten.

Seite drucken

6. Range and Boundary Loop Monitor Display:

Monitor Display(LMD) provides a visual indication of the status of your boundary

wire and signal range. On traditional boundary wire configurations, each number

on the scale represents the signal range in feet.

being broadcast from each side of the wire.

range could indicate a partial wire break or other boundary wire problem.

boundary loop wire is broken or the signal is interrupted, the light will go out

and an audible warning will sound.

visible wire break. Contact your dealer for troubleshooting tips or to schedule an

appointment.

Note:

For non-traditional wire configurations where the boundary wires may be

close to one another, the LMD may not measure the boundary signal accurately in

feet, but is a visual setting reference point. Your DogWatch dealer will explain the

LMD setting and your actual signal range.

7. Range:

The radio signal is transmitted from the boundary wire in all directions. The

signal range (the distance the signal broadcasts from the wire) is adjusted by the

Range Control on the transmitter. The recommended signal range (on each side of

the wire) is 6-10 feet. Your DogWatch Dealer will adjust the range according to the

personality and traits of your dog. Consult your DogWatch Dealer before making

any adjustments yourself.

Signal Field:

The signal field (the area in which the dog's receiver collar detects the

signal) has two areas. The outer-most part of the signal field (~13% of the signal

field) triggers an audible warning. If your pet continues further into the signal field,

he will receive a correction. To prevent your dog from entering the signal field and

remaining in the audible area (causing depletion of the battery), the receiver

transitions from an audible warning to a short warning correction after a period of

15 seconds. This will not activate if the receiver is set to the "Audible Only" Training

Level (Level "0" - see Setting the Receiver: page 8.)

8. Training Mode:

friendly training options: Basic (Mode A) and QuickAlert

setting, your pet receives the normal audible warning followed by a correction if he

continues into the signal field. When set to QuickAlert (used primarily for harder to

train dogs), your pet receives a very quick "alert" correction followed by the normal

audible warning and correction.

NOTE: If you have multiple dogs on the system, the Training Mode setting effects

all receivers. They are

9. Rate:

The Rate can be adjusted to three levels (1 = slow, 2 = medium, 3 = fast).

When your dog gets a correction, he receives it in a series of pulses. Increasing the

Rate delivers a greater number of pulses per second. The adjustable Rate feature

operates only when the Receiver Training Level is set to Level 1, 2, or 3.

See the Receiver Levels and Transmitter Settings chart on page 9.

Note: On the back of the transmitter are four very small switches. These

switches set your transmitter to the correct broadcast frequency. Your dealer

will set these switches for your system.

Do NOT change these settings. They are for DEALER USE ONLY.

The Training Mode Switch allows you to choose between two pet

set to the same mode, Basic or QuickAlert

ALL

The Range and Boundary Loop

Range = distance the signal is

A significant change (drop) in signal

You should check around your property for a

If the

(Mode B). In the Basic