CYP CH-507RXWP Betriebshandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Medienkonverter CYP CH-507RXWP herunter. CYP CH-507RXWP 16 Seiten. Hdmi over single cat5e/6/7 wall-plate receiver
Auch für CYP CH-507RXWP: Betriebshandbuch (16 seiten)
Seite drucken
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Receiver Front Panel
1
IR 1 EXTENDER: Connect an IR Extender cable for IR signal
reception. Signals received will be transmitted from any IR blaster
connected to the transmitter unit. Ensure that the remote being
used is within the direct line-of-sight of the IR Extender.
2
IR 2 BLASTER: Connect an IR Blaster cable for IR signal transmission.
IR signals received by an IR extender connected to the transmitter
unit will be transmitted by this blaster. Place the IR Blaster in direct
line-of-sight of the equipment to be controlled.
3
RS-232 OUT: Connect to the device that is to be controlled (via
D-sub 9-pin female cable) by RS-232 commands.
4
LAN: Connect to an active network for LAN serving. When the
transmitter or any compatible LAN equipped receivers are
connected to a network, this allows the network access (including
internet access if available) to be shared between the receiver
and all connected receivers. Connect any Ethernet equipped
device e.g. a Smart TV or games console to the LAN port of a
receiver for that device to share the network/internet access.
5
HDMI OUT: Connect to a HDMI equipped TV/monitor for display of
the HDMI input source signal.
6
POWER LED: This LED will illuminate when the device is connected
to a power supply or powered by another unit via PoC.
7
LINK LED: This LED will illuminate when both the source connected
to the transmitter and the display connected to the receiver are
connected.
3
IR 1
EXTENDER
IR 2
BLASTER
RS-232
OUT
1
2
3
LINK
POWER
LAN
HDMI OUT
4
5
6 7