CYP PUV-1210PL-RX Betriebshandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Matrix Switcher CYP PUV-1210PL-RX herunter. CYP PUV-1210PL-RX 17 Seiten. Hdbaset lite transmitter
Seite drucken
3. 6. OPERATION CONTROLS AND FUNCTIONS
6.1 Transmitter Front and Rear Panels
Front
IR1
BLASTER
IR2
DC 48V
EXTENDER
1
2
3
1
DC 48V: Plug the 48V DC power supply into the unit and connect the
adaptor to an AC outlet.
2
IR1 BLASTER: Connect to the supplied iR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
3
IR2 EXTENDER: Connect to the supplied iR Extender cables for IR
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR Extender.
4
CAT5e/6/7 OUT: Connect to the Receiver unit with a single CAT5e/6/7
cable for transmission of all data signals.
5
HDMi IN: Connect to HDMI source equipment such as a DVD or Blu-
ray player.
6
STD/UPDATE Switch: This switch is reserved for factory use only.
7
RS-232 IN: Connect to a PC or Laptop with D-Sub 9-pin male cable for
the transmission of RS-232 commands.
8
POWER LED: This LED will illuminate when the device is connected to
a power supply.
9
LiNK LED: This LED will illuminate when both the Transmitter and
Receiver are connected through CAT cable. When it blinks regularly
it states the Transmitter is NOT sending signal but the Transmitter
and Receiver are linked and if it blinks irregularly it states an error has
occurred.
8
HDMI IN
4
5
Rear
RS-232 IN
STD UPDATE
6
7
POWER
LINK
8
9