Akron DECKMASTER 3440 Montage-, Betriebs- und Wartungsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Montage-, Betriebs- und Wartungsanleitung für Monitor Akron DECKMASTER 3440 herunter. Akron DECKMASTER 3440 15 Seiten. Electric monitor for standard configuration with potentiometers & u2 logic box

ERROR CODES

Error Codes consist of a two part blink code. The first digit can be 1, 2 or 3 short blinks followed by another set of short
blinks (1-9). On the last blink of the second digit the LED remains on so it appears to be a long blink, then the code
repeats itself. For example, error code 1-1 appears visually as a short blink, short pause with LED off, then a long blink,
then another short pause with the LED off, then repeats.
1-1
Rotation sensor
1-2
Elevation sensor
1-3
Swing Arm sensor (3440 Only)
1-6
Obstacle Avoidance profile missing
1-7
Rotation hard stop
1-8
Elevation hard stop
1-9
Swing Arm hard stop
2-1
Electric Riser
2-2
CAN Valve Not Calibrated
2-3
CAN Valve Not Located
ISO 9001 REGISTERED COMPANY
Rotation mag switch was not detected during a stow or deploy sequence.
Elevation mag switch was not detected during a stow or deploy sequence.
Monitor is in stowed or deployed mode and the swing arm sensor signal is lost or sending an
invalid value (regardless of mode)
The obstacle avoidance feature is turned on but the avoidance profile has not been learned
N/A
N/A
An unexpected hard stop encountered while stowing or deploying after leaving a valid stowed or
deployed position
The electric riser function has been turned on but the riser is not available on the network
Valve function turned on and paired but not yet calibrated.
Pairing process failed during setup or valve lost power and/or CAN communications while
operating
PHONE: 330.264.5678 or 800.228.1161 I FAX: 330.264.2944 or 800.531.7335 I akronbrass.com
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship. Akron Brass will repair or replace product
which fails to satisfy this warranty. Repair or replacement shall be at the discretion of Akron Brass. Products must be promptly returned to Akron Brass for warranty service.
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow
our instructions or recommendations; or anything else beyond our control. WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY STATEMENT,
AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. Further, we will not be responsible for any consequential, incidental or
indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever. No person has authority to change this warranty.
© Akron Brass Company. 2018 All rights reserved. No portion of this can be reproduced without the express written consent of Akron Brass Company.
revised: 05/18