CYP CH-1602TXR Betriebshandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Transmitter CYP CH-1602TXR herunter. CYP CH-1602TXR 16 Seiten. Hdmi over hdbaset transmitter and receiver with optical audio return oar

Seite drucken

6.3 Receiver's Front Panel

POWER AUDIO OUT IR IN1 IR OUT2

1 2 3 4

POWER LED: This LED will illuminate when the device is receiving

power.

AUDIO OUT: Connect to powered speakers or an amplifier for

stereo analog audio output.

IR IN 1: Connect to the provided IR Extender to extend the IR

control range of remotely located devices. Ensure that the remote

being used is within direct line-of-sight of the IR Extender.

IR OUT 2: Connect to the provided IR Blaster to transmit IR signals to

devices within direct line-of-sight of the IR Blaster.

RS-232 OUT: Connect to the device you wish to control via a 3-pin

adapter cable to receive RS-232 commands from the Transmitter.

When sending commands to the Transmitter side, depending on

your equipment's pinout, the Tx and Rx pins might need to be

reversed.

UPDATE: This is reserved for firmware update use only. During

normal operation the dipswitch should be set to the right.

RS-232 OUT

UPDATE