CYP CDVI-1109TXC Betriebshandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Extender CYP CDVI-1109TXC herunter. CYP CDVI-1109TXC 16 Seiten. Dvi over cat5e/6/7 with lan/poc/ir extender
Seite drucken6.2 Receiver Front and Rear Panels
Front
POWER
IR 1
IR 2
IN
OUT
1
2
3
Power LED: The LED will illuminate when the 24 V DC Adaptor is
1
connected to the AC outlet.
2
IR 1 IN: Connect to supplied the IR Receiver cables for IR signal
reception. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled. The related IR Transmitter port is IR1
OUT.
3
IR 2 OUT: Connect to the supplied IR Blaster cables for IR signal
transmission. Ensure that remote being used is within the direct line-
of-sight of the IR Extender. The related IR Receiver port is IR2 IN.
RS-232 OUT: Connect to a RS-232 enabled device with a D-Sub 9-pin
4
female cable for the transmission of RS-232 commands.
5
Link LED: The yellow LED will illuminate when both the input source
and output display signals are connected through the CAT cable.
When it blinks regularly it states the source is NOT sending a signal
to the Transmitter but the Transmitter and Receiver are linked and
if it blink irregularly it states an error has occurred.
6
CAT5e/6/7 IN: Connect the Transmitter and Receiver via a single
CAT5e/6 type cable for all data transmission.
DVI OUT: Connect to a DVI equipped display or monitor to display
7
the DVI input source signal.
8
AUDIO OUT L/R: Connect to active speakers or amplifier for audio
signal output.
9
LAN 1/2: The LAN connections can be used to connect and share
up to 4 Ethernet connections (2 at the Receiver end, 2 at the
Transmitter end), including computers, routers and media servers.
LINK
RS232
OUT
CAT5e/6/7
IN
4
5
6
Rear
AUDIO OUT
DVI OUT
L
R
7
8
LAN 1
LAN 2
9
4