CYP PU-HBTPL-ZE Betriebshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Extender CYP PU-HBTPL-ZE herunter. CYP PU-HBTPL-ZE 12 Seiten. Hdbaset lite zone extender 1 x hdmi / 1 x hdbaset out

Seite drucken
CYP PU-HBTPL-ZE Betriebshandbuch

6.2 Rear Panel

HDMI OUT
A
1
1
HDMI OUT & LINK LED: Connect to HDMI display for instant image
display or cascade with another family type Transmitter. The LINK
LED will illuminate once and active display signal is detected.
This device obtain the last memory function therefore, the device
will use the last output port's EDID when The output port is not
connected to a display after power cycling.
2
EDID: Switch to A/B to allows device to output image according to
output A/B (A: HDMI, B:CAT OUT) port's EDID. For example, switch
to A and both input and output A is connect to 4K2K's equivalence
signal, both output A and B will obtain a 4K2K's signal however
if output B is not connected with 4K2K's display there will be no
image.
3
CAT5e/6/7 OUT & LINK LED: Connect this port to CAT5e/6/7 to HDMI
Receiver with CAT5e/6/7 cable along with display to extend the
signal up to 60m. Once the connection is made with active signal
the LINK LED will illuminate.
4
IR IN: Connect with the supplied IR Extender to receive IR signal
from Transmitter side and blast out at Receiver side. Ensure that
remote controller being used is within the direct line-of-sight of the
IR Extender.
5
IR OUT: Connect with the supplied IR Blaster to blast out the IR
signal received from the Receiver side. Place the IR Blaster in direct
line-of-sight of the equipment to be controlled.
LINK
EDID
A
B
2
CAT5e/6/7 OUT
LINK
B
3
IR IN
IR OUT
4
5
4 4