Ashford INKLE LOOM Anleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Spinnende Räder Ashford INKLE LOOM herunter. Ashford INKLE LOOM 8 Seiten.

ASSEMBLY

You need a

screw driver and hammer.

NOTE: Please read finishing instructions before assembling.

Rub Candle wax or soap on the screws.

Attach the feet to the base with screws. Not too tight!

Twist feet parallel to base. Glue the spacer dowel between the 2 uprights, then immediately glue

uprights in place and secure with screws on the back side of the loom.

Glue the 11 pegs into the holes. Tap firmly with a hammer.

Secure the tension block in place with bolt, washer and wing nut. Note: tap the head of the bolt

into the wood.

Wait 24 hours for the glue to set hard.

Insert the small screw and washer into the pilot hole in the front of the base. Use this to hold

the warp thread when warping.

warp starter

screw and

washer

WARPING THE LOOM

Wrap the warp thread around the

handy warp starter.

Round 1

Take the thread around the pegs

as shown. The thread goes up

over the top peg and around the

tension block.

Start here and

change colours here

wingnut

spacer

uprights

screw

Tension block in this position to start

LONG WARP

Round 1

SHORT WARP

washer

tap head of

bolt in

tension block

peg