Ashford Jack Loom Anleitung Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Spinnende Räder Ashford Jack Loom herunter. Ashford Jack Loom 16 Seiten.

Seite drucken

22. Attach the handle to the crank with a

threading the bolt through the handle and crank. Check the handle

spins freely and then lock it with a

shaft of warp roller Z and lock in place with

the ends of the pin slightly to prevent it falling out.

NOTE: The cloth and warp roller must rotate in the direction shown.

3/32 Dome Cap

Harness Hook

M8 x 100 Cup Head Bolt

. Locate crank onto the

M8 Hex Nut

6.5 x 40 Cotter Pin

23. Wipe the stainless steel bars with a clean cloth to remove any

protective grease. Your Ashford 8 Shaft Jack Loom has been supplied

with Texsolv Heddles. Each bundle contains 100 heddles which enable

you to use 100 per shaft.

Take a bundle of heddles (DO NOT REMOVE THE PINK TIES).

Thread 2 round steel bars through the holes in a shafts, through the

gaps in the top and bottom of the bundles and into the holes in the

other end of the shaft. Then push

in the outside of the shaft to lock the steel rods in place.

NOTE: Ensure the

the holes so they do not protrude or drag on the nylon guides.

THEN remove the ties and spread the heddles evenly either side of the

centre hole.

The heddles can be used as is or can be cut with sharp scissors. Only

cut after the heddles have been loaded onto the steel rods.

24. Each shaft has holes on both edges of top and bottom rails. The hole

for the jack pin is exactly in the centre of the bottom rail to ensure it

lifts evenly and is marked with a small hole on the front of the shaft.

Do not use this hole for a hook.

Fit one

Harness Hook

and secure by pressing a

this by supporting the hook on a corner of a table and pressing firmly

on the dome cap. Tap gently with a hammer if necessary.

NOTE: There are 4 spare dome caps for future use. Store them in a safe

place.

. Spread

M8 Hex Nut

M11 Rubber Buffers

into the top rail and the bottom rail of each shaft

3/32 Dome Cap

Spread the heddles evenly either side

of the Harness Hook and then clip the

stainless steel rods over the hooks. The

hooks prevent the bars from sagging

when being raised or pulling out when

the warp is being advanced.

Push M11 Rubber Buffers fully into the

holes to keep the steel bars in position.

M11 Rubber Buffer

HANDLE

M8 x 100

Cup Head Bolt

into the oval holes

are pushed right to the bottom of

onto the hook. It is easier to do