Ashford SAMPLEIT Anweisungen - Seite 2

Blättern Sie online oder laden Sie pdf Anweisungen für Racks & Ständer Ashford SAMPLEIT herunter. Ashford SAMPLEIT 2 Seiten. Sampleit loom stand

ASSEMBLY INSTRUCTIONS

Tools Required

1. If your loom is 25cm (10") wide, use the short footrest, if your

loom is 40cm (16") wide, use the long footrest.

2. Attach the appropriate footrest to one leg and foot as

illustrated with a 50mm (2") bolt and barrel nut and lightly

tighten with the Hex Key. Note the tapered leg fits snuggly

into the tapered rebate in the foot. Repeat for the other side.

Store the spare rail for future use.

3. Insert the 40mm (1½") round head bolts from the inside of

your loom and tap the head of the bolts flush against the

loom side. Then locate the loom and bolts into the slots in the

legs and secure with washers and knobs.

45mm (1¾") bolt

Ashford Handicrafts Limited

415 West Street, Ashburton 7700, New Zealand

Telephone 64 3 308 9087

Leg

Footrest

4. Note the support braces are left

and right. Check they are on the

correct side and attach them to

the legs with 45mm (1¾") bolts,

washers and knobs.

5. Sit at the loom and adjust the

angle of the loom and footrest to

suit. Raise the support braces up under the front cross rail

and tighten all knobs and bolts.

6. Store the Hex Key in a safe place and retighten the bolts if

required.

Enjoy weaving on your SampleIt Loom!

40mm (1½") bolt

Foot

50mm (2") bolt