Acquisitions HIW-XF03G Installations- und Gebrauchsanweisungen - Seite 9

Blättern Sie online oder laden Sie pdf Installations- und Gebrauchsanweisungen für Innenkamin Acquisitions HIW-XF03G herunter. Acquisitions HIW-XF03G 16 Seiten.

Seite drucken

8.4

FINAL FITTING

OF THE FRAME

ASSEMBLY

Due to the weight of the

facia assembly, it is recom-

mended to seek assistance

for this operation.

The facia panel is supported

by four M6 screws which pro-

trude from the front of the

outer casing. Ensure each

screw is unscrewed approxi-

mately one turn from the

fully screwed in position in

order to create a 2mm gap

(shown). Simply hang the

facia panel onto the outer

casing ensuring that the cor-

responding keyhole shaped

holes engage the screw-

heads fully.

BRIEFING

9.0

CUSTOMER

All

instructions

handed to the user for safe-

keeping. Show the customer

how to light and control the

fire.

After commissioning the appliance, the customer should be instructed on

the safe use of the appliance and the need for regular servicing. Frequency

of service depends on usage, but MUST be carried out at least once annu-

ally.

Advise that cleaning of the fire maybe achieved when the fire is cold using

a damp cloth and mild detergent on most surfaces. Advise that the fire will

emit a "newness" smell for a time after initial commissioning and that extra

ventilation may be needed during this time.

Recommend that a guard be used for the protection of the young, pets, the elderly and the infirm

SERVICING

10.0

Isolate the fire from the gas supply. Ensure that the fire is fully cold before attempting service. A sug-

gested procedure for servicing is detailed below.

1. Lay out the dustsheet and tools.

2. Remove the facia section. Removal is the reverse of fitting as detailed in section 8.4.

3. Remove the glass door assembly and clean carefully.

4. Inspect the burner and the catalysts and clean if necessary with a soft brush.

5. Disconnect the gas supply.

6. Undo the four screws retaining the burner support brackets to the base and rear of the firebox.

7. Remove the burner unit, strip off the burner pipes and clean thoroughly.

8. Clean the in-line restrictor, pilot assembly and the burner tube. Do not attempt to remove the

pilot injector as this can cause damage.

9. Re-assemble components.

10. Turn on the gas supply and check tightness. Check pilot and burner for good ignition.

11. Refit the glass door assembly, ensuring a good seal.

12. Refit the facia as detailed in section 8.4.

13. Check the purpose provided ventilation is un-obstructed.

14. Light the fire and test setting pressures.

15. Check safe operation of the appliance.

For specific servicing instructions, see relevant sections.

THE

must

7 7