Cypress CY8CPROTO-062-4343W Schnellstart-Handbuch
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Hauptplatine Cypress CY8CPROTO-062-4343W herunter. Cypress CY8CPROTO-062-4343W 3 Seiten. Psoc 6 wi-fi bt prototyping kit
Seite drucken
CY8CPROTO-062-4343W PSoC
Before starting, ensure you have the following.
• PC with USB port and Wi-Fi connectivity
• UART terminal software such as Tera Term or Minicom
• Non-enterprise Wi-Fi network with internet access or a mobile hotspot
1) Visit the kit website to download and install the required software.
2) Ensure the jumper J3 is at position 2-3 to select 3.3V.
3) Connect the KitProg3 USB connector (J8) to your PC.
4) Wait for the drivers installation to complete.
5) Open the UART terminal software and connect to the KitProg3
USB-UART COM port with the settings – Baud rate: 115200,
Data: 8 bit, Parity: None, Stop bit: 1 bit, Flow control: None.
6) Press the RESET switch (SW1) on the device.
7) Follow the instructions displayed on the UART terminal to use the
pre-programmed code example.
Refer to the Kit Guide available at the kit website for details.
© 2018 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. 002-25010 Rev.*A
6 Wi-Fi BT PROTOTYPING KIT QUICK START GUIDE
®
For more information, please visit:
KitProg3 USB connector (J8)
Reset button (SW1)
Power selection jumper (J3)
www.cypress.com/CY8CPROTO-062-4343W