Ashly MX-206 Betriebshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Musik Mixer Ashly MX-206 herunter. Ashly MX-206 12 Seiten. Stereo microphone mixer
Auch für Ashly MX-206: Betriebshandbuch (12 seiten), Technische Hinweise & Spezifikationen (2 seiten), Betriebshandbuch (8 seiten), Betriebshandbuch (9 seiten)

Operating Manual -MX-206 Stereo Microphone Mixer

8. SPECIFICATIONS

DISTORTION

THD at +20 dBu, 20Hz-20KHz, input switch at -40dB<0.05%

IMD (SMPTE) at +20dBu, input switch at -40dB . . . <0.02%

HUM & NOISE (20Hz-20KHz, input switch at -60dB)

equivalent input hum and noise . . . . . . . . . . . . . . . . . <-129dBu

residual output noise, TRS outputs,

all levels at minimum . . . . . . . . . . . . . . . . . . . . . . . . . <-100dBu

residual output noise, XLR outputs, . . . . . . . . . . . . . . <-90dBu

Master Level at nominal,

all Ch. Level controls at min . . . . . . . . . . . . . . . . . . . . <-84dBu

Master Level and one Ch. Level at nom. . . . . . . . . . . <-67dBu

MAXIMUM VOLTAGE GAIN (±2dB)

Mic Input to Master Output, 600 ohm load . . . . . . . . . . . 84dB

Aux In to Master Output . . . . . . . . . . . . . . . . . . . . . . . . . . . 34dB

FREQUENCY RESPONSE

20Hz-20KHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +0/-0.5dB

CROSSTALK

Between any inputs or outputs

20Hz-20KHz . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . <-60dB

Figure 9.1: Dimensional Drawing for MX-206 Mic Mixer

VU METERS

Two 5-segment LED meters . . . . . . . . . . . . . . . . 0VU = +4dBu

PEAK INDICATORS

Peak Clip indicator on each input channel and left and right

outputs, illuminates 3dB below clipping

PHANTOM POWER

+48 VDC applied to all Mic Inputs, switchable on front panel.

Maximum total current draw = 80mA. Maximum single chan-

nel current draw = 14mA. Gradual power-up and down to elimi-

nate "pops".

SHIPPING WEIGHT

10 lbs. maximum

POWER REQUIREMENTS

120 VAC nominal, 93 VAC minimum, 50-60 Hz,

17 watts (240 VAC available)

*unless otherwise stated, specification conditions are:

150 Ω source, Input set at "-60", all other controls set at

nominal, XLR output into 600 Ω or greater.

17.00