Cypress CE217646 Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Empfänger Cypress CE217646 herunter. Cypress CE217646 20 Seiten. Ble wireless power transfer with psoc 6 mcu with ble connectivity

Seite drucken
l.
After some time, observe the Notification of the Alert characteristic received with value 0x08 (Charge Complete). Read
the PRU Dynamic Parameter characteristic and observe the same value in the PRU Alert position (17th byte):
m. If you have some problems with the usage of the CySmart app, refer to the
6.
The CySmart mobile app (Android/iOS) does not have Wireless Power Service implementation, but still can be used in
GATT Data Base mode for test this example. You can repeat test flow for CySmart mobile app in step 5. Refer to
and
iOS
CySmart User Guide.
7.
The code example ships with the UART debug port enabled. To disable it, set the macro DEBUG_UART_ ENABLED in
common.h to DISABLED and rebuild the code.
8.
The BLE Wireless Power Transmitter project is intended to work in a pair with BLE Wireless Power Receiver. Do the
following to test Wireless Power Receiver project, using Wireless Power Transmitter project:
Plug the CY8CKIT-062-BLE kit board into your computer's USB port.
a.
Open a terminal window and perform following configuration: Baud rate – 115200, Parity – None, Stop bits – 1, Flow
b.
control – XON/XOFF. These settings must match the configuration of the PSoC Creator UART Component in the
project.
c.
Build the BLE Wireless Power Transmitter project and program it into the PSoC 6 MCU device. Choose Debug >
Program. For more information on device programming, see PSoC Creator Help. Flash for both CPUs is programmed
in a single program operation.
Plug the CY8CKIT-062-BLE kit board into your computer's USB port.
d.
Open a terminal window and perform following configuration: Baud rate – 115200, Parity – None, Stop bits – 1, Flow
e.
control – XON/XOFF. These settings must match the configuration of the PSoC Creator UART Component in the
project.
f.
Build the BLE Wireless Power Receiver project and program it into the PSoC 6 MCU device. Choose Debug >
Program. For more information on device programming, see PSoC Creator Help. Flash for both CPUs is programmed
in a single program operation.
www.cypress.com
BLE Wireless Power Transfer with PSoC 6 MCU with BLE Connectivity
Figure 8. CySmart Windows App
Document No. 002-17646 Rev.**
CySmart User
Guide.
Android
6