Akron Brass RENEGADE 3580 Montage-, Betriebs- und Wartungsanleitung
Blättern Sie online oder laden Sie pdf Montage-, Betriebs- und Wartungsanleitung für Monitor Akron Brass RENEGADE 3580 herunter. Akron Brass RENEGADE 3580 12 Seiten.
Seite drucken
INSTALLATION, OPERATING, AND MAINTENANCE INSTRUCTIONS
The following is intended to provide the basic instructions for installation, operation and maintenance of the Renegade electric
monitor, and to assist in attaining the best possible performance from the unit. Read and understand these operating instructions
before use.
TOOLS REQUIRED
• Utility Knife
• Medium Phillips screwdriver
• Small Phillips screwdriver
• Electrician's pliers (multipurpose, stripping and crimping)
PRODUCT RATINGS
Maximum Motor Current Draw:
12 volt versions
Normal Operating Current: (Depending on operating conditions–pressure, flow, etc.)
12 volt versions
Minimum Voltage: (Truck engine must be operating for proper voltage requirement.)
All 12 volt motors: 11.5 volts while operating
Mass: 150 lbs. (68 kg)
Maximum Flow: 5000 gpm (19000 lpm)
Maximum Pressure: 150 psi (14 bar)
PRODUCT WARNINGS
WARNING:
Charge the unit slowly. Rapid charging may cause a pressure surge that has the potential to cause an
injury, or damage the monitor.
WARNING:
DO NOT stow or deploy the Renegade monitor while flowing. Pressing the stow or deploy buttons
causes the nozzle to move automatically and the water stream may cause damage to equipment or
injury to personnel.
WARNING:
Aim the unit in a safe direction before pumping water through it. (i.e. Away from power lines)
WARNING:
Although the circuit board includes a water-resistant coating, it is important to keep water out of the
control box and logic box. Prolonged exposure to water will cause damage.
WARNING:
When the cover of the control box or logic box is removed, check that the O-ring under the cover is
intact and free of dirt and debris.
WARNING:
The Renegade monitor uses current limiting for both the monitor and nozzle. Use only appropriate Akron
Brass Company nozzles.
WARNING:
Do not use the electric controls when the override cranks are being used or are in position for use.
WARNING:
Make the connection of the vehicle and auxiliary battery the final step.
WARNING:
Replace the identification tags if they should become worn or damaged.
WARNING:
DO NOT exceed the maximum pressure or flow ratings of the monitor. Exceeding these ratings may lead
to an injury or may cause damage to the monitor.
STYLE 3580 RENEGADE™
• Medium flat screwdriver
• Small flat screwdriver
1
•
/
inch hex head wrench
2
4 amps each for elevation and rotation motors
4 amps for nozzle pattern motor
2 to 3 amps each for elevation and rotation
2 to 3 amps for nozzle pattern motor
119293