Cypress Envirosystems WPT Schnellstart-Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Gateway Cypress Envirosystems WPT herunter. Cypress Envirosystems WPT 8 Seiten. Gateway and server

Seite drucken
2.2
Configuration
To configure the WPT LoRa Gateway and Server, a single setup file (csv format) is
used along with software on the LoRa Server (LoRa COM Device Importer).
1. For each WPT, add an entry into the csv setup file. This setup file can be edited
in any text editor. A sample version of this file is located on the server
(c:\WPT\Cypress_WPT_Info_OTAA.csv).
The setup file has the following comma-separated fields.
•
DevEUI:
o
•
NodeID:
o
•
NodeName:
o
•
Location:
o
•
BACnet ID:
o
NOTE: In some instances, there may be an existing LoRa gateway on premises.
If the gateway is not a WPT Blue Box, you will need additional parameters to
manually enter the WPTs to the existing LoRa gateway. Please refer to the
Installation Manual (910-00031-01) for additional details.
Figure 3: Sample setup file (Cypress_WPT_Info_OTAA.csv) location
The device equipment unique identifier. For the WPT, this is the
MAC ID of the WPT. The setup file only needs the last 4 bytes of the
WPT MAC ID.
NOTE: The full MAC ID is labeled on the WPT. Additionally, the
lower 4 bytes (Byte 4 – Byte 7) can also be displayed using the WPT
LCD in the Diagnostic Menu. Please refer to the WPT manual for
further information.
The user assigned Node ID for the WPT. This should matches with
the Node ID configured at WPT.
The user assigned name of the WPT
The location of the WPT
The user assigned BACnet ID of the WPT
WPT Gateway and Server
Quick Start Guide
Document No. 910-00029-01, Rev 02
Page 4 of 8