ACR Electronics 406 PLB Handbuch zur Produktunterstützung - Seite 14
Blättern Sie online oder laden Sie pdf Handbuch zur Produktunterstützung für GPS ACR Electronics 406 PLB herunter. ACR Electronics 406 PLB 20 Seiten. Personal locator beacon
Seite drucken
Upon lifting the switch, a very short yellow flash will indicate self test has been initiated.
Sequence of Tests
1. Check Data I/O ....................................... Beep & flash amber LED if pass
................................................................. Stop if failed
2. Check 406 MHz Synthesizer
................................................................. Beep & flash amber LED if pass
................................................................. Stop if failed
3. Check RF Power/Battery ........................ Beep & flash amber LED if pass
................................................................. Stop if failed
4. Unit turns on green LED to indicate Successful Test.
5. On the GyPSI™ 406 PLB approximately 2 seconds after green LED flash, unit will flash
amber LED and beep if valid external GPS data has been received.
A successful test result is indicated by three beeps, three yellow flashes then the green LED
flashes. If GPS data has been loaded into the PLB, an additional yellow flash & beep will
occur after the green LED flashes.
NOTE: The homing beacon at 121.5 MHz is inhibited during self test.
It is strongly recommended to test the PLB on a quarterly basis.
SELF TEST
FIGURE 5
11
Y1-03-0169 Rev. B