EG EG Oahu 500EX Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Fahrrad EG EG Oahu 500EX herunter. EG EG Oahu 500EX 8 Seiten.

INSTALLATION INSTRUCTIONS

1. Unpack the bicycle from the box and cut all the ties that held the bicycle together during

shipping.

2. Install the handle bar by inserting the handlebar stem into the head tube. An Allen key is

supplied to install the handle bar stem.

Adjust the handlebar by loosening the nut holding the handlebar and then re-tightening it with

the included allen wrench.

4. ! WARNING: Do NOT over tighten nut against the fork; for you will risk damaging your

suspension fork.

The front and rear LED/reflector Lamp runs on regular AA or AAA batteries. The Front LED is

turned on/off by clicking on the button on top of the lamp. The rear LED lamp switch in under

the rear LED. Remove the plastic tabs in the battery to start using them.

6. Install the pedals to the bike. Each of the pedals has a letter indicating which side it needs to

be installed to. R=Right and L=Left. Install them using the provided wrench.

! WARNING: Before riding the bicycle ensure the main Li-on battery is properly installed and

locked in before riding the bicycle. If the Battery is not firmly locked onto the holder. it may slide

out and cause damage to the battery.

Insert the battery into the battery holder by aligning the side tabs and then lock in your battery

with provided key. Ensure that the rails/tabs are properly aligned below the battery. Ensure that

the battery is locked in by lightly tugging on the battery upward to ensure it will not slide out.