EG Milan Ergänzung zum Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Ergänzung zum Benutzerhandbuch für Fahrrad EG Milan herunter. EG Milan 8 Seiten.

 ! NOTE: Always plug the charger onto the Battery pack before plugging the charger to the wall

socket.

 ! WARNING: Do NOT charge the battery for more than 24hrs for risk of damaging the battery.

Repair and Service

！WARNING:

 Inspect the bicycle frequently. Failure to inspect the bicycle and to make repairs or

adjustments, as necessary, can result in injury to the rider or to others. Make sure all parts are

correctly assembled and adjusted as written in the owner's manual.

 Immediately replace any damaged, missing, or worn parts.

 Make sure all fasteners are correctly tightened as written in the owner's manual

 Parts that are not properly tightened can be lost or operate poorly.

 Do not over tighten parts, as over-tightening may damage the part.

 Make sure any replacement fasteners are of the correct type and size.

 Your bike uses an Aluminum Alloy frame. Ensure that the bicycle frame is carefully and

frequently inspected; as Aluminum frames can develop micro fractures from stress, severe

impact and shocks. If you see these micro fractures or cracks, stop riding the bicycle

immediately.

 In case of micro fractures, have the bicycle frame repaired and inspected by a qualified

professional before riding the bicycle again.

NOTE: Have a bicycle service shop make any repairs or adjustments for which you do not have the

correct tools to or if you do not sufficiently understand the instructions set forth in this electric bicycle's

manual supplement or the bicycle owner's manual.

Inspection of the Bearings Maintenance

1. Frequently check the bearings of the bicycle. Have a bicycle service shop lubricate the bearing

once a year or any time they do not pass the tests as noted in the Bicycle owner's manual.

1. There are 3 serial numbers that are of importance on your EG Electric Bike. They are the

Frame serial number, the Motor serial number and the Battery pack serial number. All the 3

serial numbers can be found on the outside of the box the bicycle was shipped in.

2. The Bike Frame Serial number to your EG Electric Bike is located right where the front Fork /

Suspension fork meets the frame of the bike. It is at the front of the frame right near where you

install the front reflector to the bike.

3. The Motor serial number is located on the side of the motor.

4. The Battery serial number is located at the bottom of the Battery pack.

1. ! WARNING: We do not condone modifying the EG Electric Bicycle in any way shape or form.

Modifying the bike in any way, will void your Warranty. The instructions below are written only

for the maintenance or repair of the bike.

2. To detach the rear wheel, first unhook the connector near the rear wheel on the right hand side

of the bike.

3. Remove the plastic covers over the screws on the rear axle.

4. Unscrew the nuts on both sides of the rear axle and the wheel should come right off.

5. Unhook the chains from the rear freewheel (gears)

6. To install it back on, please note and reverse all the detachment instructions.