Asko 1755 Gebrauchsanweisung - Seite 7
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Geschirrspüler Asko 1755 herunter. Asko 1755 13 Seiten. Asko 1755: user guide
Seite drucken• Want to change your
mind?
If you want to change programme
after you have started the machine,
press one of the programme buttons
for 3 seconds. Then select a new
programme.
Dishwashing programmes
Indication lamps, see page 8
Programme features
=The dirty rinse water is emptied and the next period starts
with clean water (SCS= Super Cleaning System)
Main wash
Pre-wash
45
o
65
o
o
30
65
o
30
o
o
65
55
o
NOTE:
When you select an option (
• To activate and save an option, you must start a programme. The reason for this is to prevent children playing
with the pushbuttons and changing the temperature etc..
By re-programming
• The choice will remain till you change it.
Even by stopping the machine with the main on/off button or if the machine by other reason has been out of
power, all choises will remain, which were activated before the power failure.
• The choise will be shown for 2 seconds by the lamps. Then the machine will revert to the main programme.
• A black filled symbol means a lit lamp.
Lines over a lamp means that it is blinking.
• If you turn off the machine
at the main on/off switch
(or if there is a power failure) before
the programme has finished, the
programme will continue when
power is restored.
If the power is turned off during
drying, and the door is open for
more than two minutes, the
programme will be terminated.
Option, see below
Hot fill
ca 60°C
Cycle time,
Rinses
Drying
approx. min.**
o
70
90
o
65
70
65
o
70
o
55
30
4
= heat
), remember this:
Consumption figures
Cold fill
ca 15°C
Energy
Cycle time,
Energy
approx. min.**
kWh ca**
kWh ca**
1,1
120
2,2
0,9
95
1,6
0,8
95
1,5
0,3
50
1,0
0,01
4
0,01
= without heat
• After washing
When the machine has stopped, it
consumes only an extremely low
power. To turn it off completely, turn
off the main on/off switch.
The indicating lamp remains on as
long as the switch is in the On
position. It is a good rule never to
leave a switched-on machine
unattended.
How to save
energy:
Wash only full loads
Save energy by not using the
machine until it is full.
Is the machine connected
to a cold water supply?
If the machine is connected to a
cold water supply, running time
will be longer, as the machine
must heat the water. However,
the longer washing time means
that you can run the programme
at a lower temperature and still
get the same wash performan-
ce. You also save electricity.
Select unheated drying
If you select unheated drying,
Water
the dishes will dry a little more
consump.
in litres
slowly. You can speed up
drying by opening the door a
25
little to allow the moist air to
escape.
16,5
* For a dishwasher with water
softener the figures are about 2
16,5
litres higher.
** The programme times shown
15
in the table are rounded-off
values from actual tests. In
prac-tice, times may vary some-
3,5
what due to the temperature of
the water supply, voltage
variations etc.
7