Asko D3350 Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Geschirrspüler Asko D3350 herunter. Asko D3350 2 Seiten. User manual use & care guide fr
Auch für Asko D3350: Handbuch für Gebrauch und Pflege (16 seiten), (Spanisch) Uso Y Cuidado (16 seiten), (German) Benutzerhandbuch (16 seiten)

1. Load the dishwasher. (There's no need to pre-rinse. Simply scrape off large food particles before you

load the dishware.)

2. After you've pushed the baskets back inside the unit, manually rotate the upper and lower spray arms

to be sure they turn freely. Rearrange any item that blocks the wash arms.

3. Add 1 to 3 tablespoons of automatic dishwashing detergent and close the dispenser cover.

(See "Dishwashing Detergent" below.)

4. Make sure there is rinse aid in the dispenser. Add rinse aid, if needed.

5. Press the main power button on the top left side of the inner door panel to turn on power to the machine.

6. Close the door securely. (You should hear it click shut.)

7. Press the Program button until the desired program lights up.

8. Set the Temperature and Dry options as desired. Set Delay Start time, if desired.

9. Press the Start/Stop button. The dishwasher will start.

Once you have selected the wash program and options, press this button to start the dishwasher. (Make sure the door is securely closed.)

After you press Start, the display window shows the time it took the program to run last time. (The first time you run a program, a 1 will display.)

As the program progresses, the time remaining displays. If the time exceeds an hour, the display alternates between the hour and minutes

remaining. The hour is designated by an h, e.g., 1h).

NOTE: The program times may not always be the same because of variations in the household hot water temperature. The dishwasher

heats the water to the proper temperature for the program selected; so if the temperature of the water entering the dishwasher is too low, the

dishwasher will run longer because it takes longer to heat the water. Raising your water heater setting could help to shorten the cycle times.

If you select Delayed Start, the window will display the number of hours selected. The window will then display the count down time until the

program starts.

The window also displays fault codes. See page 11 in your Use and Care Guide for a definition of these codes.

If you want to interrupt a program to add an item, open the door slightly until the spray arms stop turning. You can then open the door fully and

place the item into the dishwasher. Close the door securely. The program will continue from where it was interrupted.

WARNING! Be extremely careful when opening the door during a program. The water is hot and you could get scalded.

If you decide to change the program after you have started the machine, press the Start/Stop button for three seconds. You will have to select

the program and options again when you are ready to restart the program. (Note: If the program has already gone through the wash cycle,

you will have to add detergent.)

We recommend that you use only unscented, granular automatic dishwashing detergent. Generally, one tablespoon of detergent is needed

for a normal wash load. More heavily soiled items, however, may need more detergent. Also, the amount of detergent needed can vary due

to differences in water hardness. The harder the water, the more detergent you may need. (See page 5.) In any case, you should never use

more than three tablespoons of detergent.

Using liquid rinse aid prevents water spots from forming on dishes and improves drying by allowing water to "sheet" off the dishes. The rinse

aid is released during the final rinse. For information on how to fill the rinse aid dispenser and control the amount released, refer to your Use

and Care Guide.

NOTE: If you use a dishwashing detergent with a rinse aid additive, you should not fill the rinse aid dispenser.

To prevent a child from accidentally starting the dishwasher or changing the program settings, the dishwasher can be programmed not to

start unless two buttons are held down simultaneously. Refer to your Use and Care Guide for instructions on how to activate this feature.

Refer to your Use and Care Guide for additional information.

Refer to this page in

the Use & Care Guide.

3, 4

Art. 8075644