d&b audiotechnik 10A, 10A-D Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Redner d&b audiotechnik 10A, 10A-D herunter. d&b audiotechnik 10A, 10A-D 13 Seiten. 2-way loudspeakers

Seite drucken

Fig. 5: NL4 cable connection with cover plate [1]

d&b 10A/10A-D Manual (1.1 EN)

NL4 connection with cover plate

The two NL4 connector sockets of the cabinet's connector panel

are located in a recess to allow the use of the cover plate [1]

together with NL4 cable connectors, as shown in the graphic

opposite.

Note: Neutrik NL4FC type connectors must be used for this

option.

The cover plate is equipped with two knockout openings to allow

daisy chaining of the loudspeaker.

To use the NL4 connection, proceed in the same manner as

described above in the section entitled Þ "Fixed cable connection"

on page 6.

2.3. Operation

NOTICE!

Only operate d&b loudspeakers with a correctly configured d&b

amplifier, otherwise there is a risk of damaging the loudspeaker

components.

Operation with D6 or D12

Select the controller setup 10S/A for 10A loudspeakers.

Select the controller setup 10S/A-D for 10A-D loudspeakers.

Within the D12 amplifier they are available in "Dual Channel" or

"Mix TOP/SUB" mode. For combinations with active subwoofers

fed by a single 4-wire cable "Mix TOP/SUB" mode must be

selected.

Up to a total of three 10A or 10A-D loudspeakers can be driven

by each channel of the D6 or D12 amplifiers.

2.3.1. Controller settings

For acoustic adjustment the functions CUT, HFA and CPL can be

selected.

CUT circuit

Set to CUT, the cabinet low frequency level is reduced. The

cabinets are now configured for use with d&b active subwoofers.