ACR Electronics HydroFix Y1-06-0209G Handbuch für Installationsverfahren - Seite 12
Blättern Sie online oder laden Sie pdf Handbuch für Installationsverfahren für Sicherheitsvorrichtung für die Schifffahrt ACR Electronics HydroFix Y1-06-0209G herunter. ACR Electronics HydroFix Y1-06-0209G 18 Seiten. Acr electronics hydrostatic release unit installation manual
Seite drucken
SECTION 6 – INSTALLING THE HRU IN A SeaShelter™
BRACKET
The ACR SeaShelter™ is a discontinued
product that looks like this:
Contents of the HydroFix™ HRU Kit that you will need:
HydroFix™ Replacement Hydrostatic Release Unit (E)
SeaShelter™ release rod (A)
Keyed bracket adapter (D)
Large cotter pin (H)
HRU expiration label (K)
Tools required: Flat-head screwdriver
Instructions:
1.) Remove the front cover and
carefully release the EPIRB
from the bracket. If the front
cover
contains
where the HRU rod is secured
close (see Figure A), use a
flat-head screwdriver and pry
the bushing out of the top case and discard. This bushing prevents
the HRU rod from securing to the cotter pin.
2.) Remove the old HRU unit and rod from the bracket by pressing the
spring release back and sliding the old HRU up and out of the
bracket.
3.) Take SeaShelter™ release rod (A) and place it on top of the rod on
the HRU aligning the two sets of holes on the base (see Figure B).
4.) Place large cotter pin (H) inside the two holes, securing the two rods
together.
Y1-06-0209G
of
the
SeaShelter™
a
metal
bushing
Figure A
11