d&b audiotechnik Z Series Montageanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Montageanleitung für Racks & Ständer d&b audiotechnik Z Series herunter. d&b audiotechnik Z Series 10 Seiten. Al flying adapter
Auch für d&b audiotechnik Z Series: Montageanleitung (14 seiten), Montageanleitung (8 seiten), Montageanleitung (7 seiten), Montageanleitung (11 seiten), Handbuch Takelage (18 seiten), Montageanleitung (12 seiten)

Preparing the cabinet

The threaded inserts of the cabinet are covered by dummy caps in

cabinet color. To remove the caps, proceed as follows:

1. Cut out the caps along the recessed spline using an

appropriate cutting knife.

2. Carefully take off the caps and ensure the cabinet coating is

not peeled off.

Attaching the bracket to the cabinet

NOTICE!

Only use the supplied and specified screws [2], otherwise there is

a risk of damaging the threaded inserts.

Always use the spring washers [3] and U washers [4] to prevent

the bolts from slackening.

Tools required:

▪ Open-ended spanner/wrench (size #17)

1. From the rear, attach the bracket to the cabinet as shown in

the graphic opposite.

2. Insert the screws together with the spring and U washers.

3. Properly tighten all screws.

1.6 Adjustments

The vertical and the horizontal aiming can be set continuously.

Vertical aiming

Tools required:

▪ Allen key (size #8)

1. Slightly slacken the fixing screws [F] on both sides.

2. Set the loudspeaker to the required vertical angle.

3. Retighten the fixing screws [F] on both sides.

Horizontal aiming

The horizontal aiming is set via the TV spigot assembly or the

loudspeaker stand adapter.

d&b Z5553 Mounting instructions 1.2 en