d&b audiotechnik Ti10 Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für Lautsprechersystem d&b audiotechnik Ti10 herunter. d&b audiotechnik Ti10 10 Seiten.
Auch für d&b audiotechnik Ti10: Benutzerhandbuch (14 seiten)

Seite drucken
d&b audiotechnik Ti10 Handbuch
1+
1-
2+
passive
2-
crossover
1+
1-
2+
2-
Fig. 5: Connector wiring
Ti10 Manual

Connections

The Ti10 cabinet is fitted with a pair of NL4 connectors. All pins of both
connectors are wired in parallel. The Ti10 uses the pin assignments 1+/
1–. Pins 2+/2– are designated to active subwoofers. Using one
connector as the input, the second connector allows for direct connection
to additional loudspeakers.
The weather resistant (WR) version of the Ti10 is equipped with a fixed
input cable (5 m / 16.4 ft, type H-07-RN-F 2 x 2.5 mm
Pin equivalents of NL4 connectors and the fixed cable option are listed in
the table below.
NL4
1+
Fixed cable (PG)
Brown (+)

Operation

NOTICE!
Only operate d&b loudspeakers with a correctly configured d&b
amplifier, otherwise there is a risk of damaging the loudspeaker
components.
Applicable d&b amplifiers:
D80/D20/D12/D6/10D/30D.
Application
Setup
Ti10L
T10 Arc / T10 Line
Ti10P
T10 PS
The applicable d&b amplifiers provide three setups ("Arc", "Line" or "PS")
for the Ti10 loudspeaker. These are available in Dual Channel or Mix
TOP/SUB mode.
"T10 Arc" and "T10 Line" setups
These setups are selected when Ti10L loudspeakers are used. The
selection depends on the curvature of the array. Both setups may be used
within one array.
The "Arc" setup is used for Ti10L loudspeakers when used in curved array
sections.
The "Line" setup is used for long throw array sections with three or more
consecutive splay settings of 0°, 1°or 2°. Compared to the "Arc" setup,
the upper mid range is reduced to compensate for the extended near
field.
The transition from "Line" to "Arc" configuration within the array is made
according to the splay progression but may allow for certain deviations
due to the wiring of the cabinets in groups of up to four.
"T10 PS" setup
This setup has to be selected when Ti10 loudspeakers are configured as a
point source or when used as single cabinets with horn in line array
configuration (e.g. front fill or ceiling mounted).
(1.1 en)
2
/AWG 13).
2+
1–
Blue (–)
Cabinets per channel
4
4
Page 6 of 10
2–