d&b audiotechnik R70 Handbuch - Seite 11
Blättern Sie online oder laden Sie pdf Handbuch für Aufnahmegeräte d&b audiotechnik R70 herunter. d&b audiotechnik R70 20 Seiten. Ethernet to can interface
Auch für d&b audiotechnik R70: Kurzanleitung (2 seiten)
Seite druckend&b audiotechnik GmbH
[4]
[5]
[6]
[7]
[R]
(1.4 EN)
2.2.2. Indicators (Status LEDs)
The R70 interface is equipped with four LEDs for visual status control of
the device. The function of each LED is described in the table below:
LED (Col. [Pos.]) Status:
LAN (Green [4])
Off:
Rapid flashing:
ERR (Red [5])
Off:
On:
Flashing:
CAN (Green [6])
Off:
On:
Slow flashing:
Flashing:
ON (Green [7])
Off:
On:
Flashing:
2.2.3. RESET [R]
The RESET switch (push button) is located on the right hand side panel
of the device and allows for a reset of the device to factory default. To
reset the device, proceed as follows:
1.
Disconnect the power from the device.
2.
Press and hold the reset switch while reconnecting the power
and continue pressing down the reset switch for approx 3 s.
During this time the reset is executed while the ERR-LED is
flashing and the CAN-LED lights up. After successful reset all
status LEDs light up.
3.
Release the reset switch.
R70 Hardware
Description
No active Ethernet connection
Active Ethernet connection
No error
Device is in Bus off mode
CAN error
No CAN data transfer
Operational state
Stopped state
CAN message received
(through an active Ethernet
connection)
Device is shut off
Status OK
Initializing
Page 11 of 20