BlueSky Mast 350G XL Series Schnellreferenzblatt - Seite 2
Blättern Sie online oder laden Sie pdf Schnellreferenzblatt für Hebesysteme BlueSky Mast 350G XL Series herunter. BlueSky Mast 350G XL Series 10 Seiten.
Auch für BlueSky Mast 350G XL Series: Kurzreferenz (10 seiten)
Seite drucken
1
Stand the 350G XL Tripod up
and make sure the base plates
are flat on the ground.
6
Extend the two tripod legs
adjacent to the winch. DO NOT
extend the tilt leg at this time.
11
Release the cam lock on the
bottom of the tripod.
16
Pull the pin out and slide it onto
the mounting pole. DO NOT
secure it at this time.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2016 Allendale LLC All Rights Reserved
350G XL - Lift Series
Quick Reference Sheet - Primary & Secondary Guying
2
Loosen the red turn knobs on the
cross links of each tripod leg to
extend the legs.
7
Locate the stake bag with
hammer and tripod stakes.
12
Insert the mounting pole until one
hole is showing below the cam
lock and Lock the Cam Lock.
17
Mount your equipment to the
mounting pole and secure all
cables using Velcro Straps.
DEPLOYMENT
3
One at a time, slowly push down
on the red turn knobs while pulling
the leg out to extend it.
8
At a slight angle, drive a stake into
the left hole on each of the two
extend tripod leg base plates.
13
Locate the Blue Secondary Guy
Ring in the guying bag.
18
Push the tripod upright, extend the
tilt leg and tighten the red turn
knob.
Read Manual Before Use
Refer to detailed instructions in the
350G XL Lift Series Manual at all times
4
Push the cross links all the way
down and tighten the red turn
knobs to secure them.
9
DO NOT stake the holes on the
right side at this time.
14
Release the cam lock and slide it
onto the mounting pole. DO NOT
secure it at this time.
19
Make sure the base plates on the
three tripod legs are flat on the
ground.
5
Loosen the turn knobs on the two
tripod legs adjacent to the winch.
10
Locate the mounting pole in Hard
Case #2. It's the only pole without
a gold insert.
15
Locate the Red Primary Guy Ring
in the guying bag.
20
Using the three bubble levels,
level the tripod by adjusting the
tripod legs one at a time.