D&K Minikote Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Laminiergerät D&K Minikote herunter. D&K Minikote 17 Seiten.

C. Threading the Film

Remove the feed tray and the heatguard. Thread the lm as

shown in the gure on the right. Pull the lm around the idler

rollers as shown. Do not mistake the reinforcing bar for the

Do not mistake the reinforcing bar for the

idler roller

idler roller. Make sure the glossy and dull sides of the lm

Make sure the glossy and dull sides of the lm

are as indicated in the diagram

are as indicated in the diagram. Position the threading board

provided.

Turn power and keyswitch to on.

Start the motor by pressing the "Start" but-

ton, and reduce the speed to 1 foot/min.

Feed the threading board and lm in be-

tween the heat shoes. This will pull the lm

through the rollers until it comes out the

back of the laminator.

Slide the top and bottom lm rolls from side

to side on the mandrels so that the lm is

perfectly aligned top and bottom (Note:

overlap will cause the lm to deposit resi-

due on the heat shoes and rollers, so this

procedure is critical). Replace feed tray

and heat guard.

Laminator.com