Ambient NanoLockit Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Aufnahmegeräte Ambient NanoLockit herunter. Ambient NanoLockit 2 Seiten. Timecode + logging
Auch für Ambient NanoLockit: Schnellstart-Handbuch (2 seiten), Kurzanleitung für die Inbetriebnahme (20 seiten), Schnellstart-Handbuch (5 seiten), Handbuch (4 seiten), Anleitung (5 seiten), Kurzanleitung (2 seiten), Handbuch (19 seiten)

Ambient NanoLockit Schnellstart-Handbuch
4A

Sync Your Devices

Option A
Device with timecode
interface: connect
NanoLockit to TC input.
NOTE: Adjust the device menu settings to
accept external timecode. Please check the
manufacturer's manual.
4B
Sync Your Devices
Option B
DSLR & cameras
without timecode
interface: connect
NanoLockit with audio
input and set audio
level. TC signal will be
written on audio track.
Learn more about the NanoLockit and watch helpful
tutorials at
nanolockit.com
and ambient.de/en/university.
www.nanolockit.com/guide

Setting the TC Audio Level

Track levels must be set
correctly:
TC
FPS
1. Manually set the camera
audio input level to 50%
of the range.
2. Adjust the NanoLockit
TC output level so the
meter falls between
–30 dB to –20 dB.
TC IN
Hold green button
and repeatedly
press red button
to reduce
level.
TC
T
K I
C
O
L
O
N
A
N
5

Final Setup

Congratulations!
All your devices
are now in perfect
timecode sync.
Sound recording
Sound rec.
Manual
Rec. level
NANOLOCKIT
Wind filter
Disable
– dB 40
L
R
Hold red button
and repeatedly
press green
button to
increase level.
tap
hold
tap
TC 01:23:45:12
25 fps
TC IN
NANOLOCKIT
TC OUT
NANOLOCKIT
Audio Recorder
DSLR Camera

Turn Off

To switch off the NanoLockit, press and hold
the power button for 5 seconds until the
LED lights up red
0
NOTE: Power down your NanoLockit manually after
charging/supplying with external power to avoid battery
drain when not in use.
SPECIAL
TRX Mode
NOTE: Source timecode and Lockits are not synchronized.
This may lead to drift between source and receivers on
long takes. Do not use for standard sync situations.
Only intended for sending a prere-
corded timecode to slates or remotely
start/stop recorders via external record
run timecode.
hold
Start all NanoLockits by holding the
red button and tap the power button.
The units will switch to channel 11
and blink in TRX idle mode
Timecode from an external source can now be sent
from one device to other devices.
This external source must be
permanently connected
to this NanoLockit
via TC input or MIDI USB.
The NanoLockits will
now automatically
start and stop their
generators along
with the source.
NANOLOCKIT
Film Camera
.
5 sec
hold
3 sec
tap
.
REC
TC
TC IN
NANOLOCKIT
TC OUT
NANOLOCKIT
NANOLOCKIT
Audio Recorder
DSLR Camera
Film Camera